Junger-audio D*AP8 Digital Audio Processor Manual do Utilizador descarregar pdf (Página 41)

D*AP8

Setup GUI – INTERFACES – 8 Ch Analog Out Interface

Analog Output Calibration sets the factor for D/A conversion

(dBu) (level for digital 0 dBFS)

ANLx (dBu) [0.0 … 15.0 … 24.0]

output level for output "x" at 0dBFS.

The default setting of 15.0dBu correlates to the 6dBu = -9dBFS

conversion.

Setup GUI – INTERFACES – 4 Ch Analog I/O Interface

An additional analog interface can be installed in the Interface slot.

It provides 4 additional analog line inputs and outputs on a 25pin D-Sub connector:

Enable Relay Bypass [ON / OFF]

(All Channels) Power fail bypass relay that may be activated from the GUI

Analog Input Calibration [0 … 15.0 … 24.0]

(dBu)

(level for digital 0 dBFS)

A/D conversion parameter. It defines the analog input level in dBu

to reach a digital full scale signal.

Analog Output Calibration [0 … 15.0 … 24]

(dBu)

(level for digital 0 dBFS)

D/A conversion parameter. It defines the analog output level in dBu

for a digital full scale signal.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 99 100

Sem comentários

Junger-audio D*AP8 Digital Audio Processor Manual do Utilizador Página 41