Junger-audio D*AP8 Digital Audio Processor Manual do Utilizador descarregar pdf (Página 42)

D*AP8

Setup GUI – INTERFACES – AES Interface – Status / Setup

An additional AES3 interface can be installed in the Interface slot.

It provides 4 additional AES3 inputs and outputs on a 25pin D-Sub connector:

Status

Input Signal Status green [OK] / red [Fail]

Input Signal Type [Mute / PCM / Non PCM]}

Settings

Enable Relay Bypass [ON / OFF]

(All Channels) Power fail bypass relay that may be activated from the GUI

Input Sample Rate [ON / OFF]

Converter

Output Channel Status [Transparent / Prof PCM / Prof Non-PCM / Cons PCM /

Cons Non-PCM]

Controls the channel status for the AES output. It provides a set of

useful channel status information (e.g. to prevent non audio signals

to be fed to speakers).

Important note! The AES relay bypass circuit of the I/Os is activated on the option board. It is possible to

deactivate it if necessary. You must open the cover plate from the D*AP8 unit and locate the jumper

shown in the schematic below. You must remove the jumpers to de-activate the AES I/O relay

power fail circuit.

The bulk jumpers J13, 23, 33, 43

at the bottom of the picture

are meant for setting the I/Os

to unbalanced operation.

Putting them into the lower position

will turn to unbalanced.

Factory default setting is balanced.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 99 100

Sem comentários

Junger-audio D*AP8 Digital Audio Processor Manual do Utilizador Página 42